23
DEUTSCH
ENGLISH
FRANÇAIS
IT
ALIANO
NEDERLANDS
SVENSKA
ESP
AÑOL
PORTUGUÊS
Detachable face (release panel)
Detaching and attaching the face:
The face of this unit can be detached and taken with you to prevent it from being stolen.
Detaching the face:
Press the REL (release) button and detach the face by gently pulling it off as illustrated.
Note: Do not pull it straight out from the chassis. Be sure not to drop the face when detaching it
from the chassis. When carrying the face with you, put it in the carrying case. Do not expose the
face to direct sunlight, heat sources such as hot air ducts or leave it in a humid place.
Attaching the face:
Apply the right hand side of the face to the chassis by sliding (part B) of the face to (part A) at
the front of the chassis. Gently push the left side of the face against the front of the chassis until
it snaps into place.
Note: Do not press against the display window. Do not press hard against the face when
attaching it to the chassis, it may be easily attached with gentle pressure.
Cleaning the connectors
The unit may not operate properly if the connectors between the unit and the face are
contaminated with dirt. In order to prevent this from happening, remove the face from the unit by
pressing REL (release button), then detach it and clean the connectors from time to time. Clean
the connectors with a cotton swab and isopropyl alcohol (90% or higher). Be sure to clean them
with a vertical motion. Never clean them horizontally, because this could damage the contact
points.
Affixing the faceplate for retail display:
The faceplate can be affixed to the unit’s chassis, which is desirable for a retail display, for
example.
To affix the faceplate:
Insert the black bolt into the hole at the left front of the top of the radio. See * below.
*
A
B
Valencia CM127 gb®
28.01.2004, 9:30 Uhr
23