INSTALLATION
Recommendations
Carefully choose the mounting location so that the unit won’t interfere with normal driving.
Avoid mounting locations where the unit would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where
it would subject to dust, dirt or excessive
The Illustration below shows a
installation, however, you may need to adjust the
depending on the unit. If you have questions or need additional installation
hardware, consult your Blaupunkt dealer.
l
Make sure the
firmly anchored (preferably at both front and back)
and does not vibrate.
Mounting the Unit in a Japanese Car
You may have
this unit in some Japanese cars.
In this case, consult your Blaupunkt dealer.
Removing the Unit
Use the Release Keys as shown below. Keep them in a safe place in case
in the future.
MAINTENANCE
Mounting The Unit in Most Dashboards
1
Install the Sleeve in the dashboard.
2 Select and bend the appropriate tabs to hold the sleeve firmly in place.
3
A.
Attach the Mounting Strap to the underside of the dashboard, using screw.
B.
Attach the back of the unit to the mounting strap using the support stem bolt and hardware.
Bend these tabs
You need them
Fuse Replacement
When
the fuse. be sure to use one with the correct amperage,
will be slated on the fuse case. Never use a fuse that has a stated amperage exceeding the one
supplied for this
as this could cause
and serious damage to the
SPECIFICATIONS
Power Specifications
Power Output and Total Harmonic Distortion: 10 watts per channel minimum continuous average output into 4 ohms, 4 channels driven, from 30-15.000 Hz with no more than 1%
total
.
Specifications
Tuner
FM
Tuning Range:
FM Mono
Selectivity:
Signal-to-Noise Ratio:
Harmonic distortion at 1
Separation:
Frequency Response:
Tuning Range:
Seek lo
Seek sensitivity:
Intermediate Frequency:
Signal-to-Noise Ratio:
530 1,710
55
35
45
Design and specifications subject lo change
notice.
87.5 107.9
10.7
18
75
at 400
85
(stereo), 70
(mono)
0.7% (stereo), 0.5% (mono)
30
30-l 5,000 Hz 3
. .
Audio
Speaker Impedance:
Maximum
Power:
RMS Power:
Bass Control:
Treble Control:
Cassette
Signal-to-Noise Ratio:
Tape Wow and Flutter:
Tape Frequency Response:
General
4-8 ohms
30 Watts 4 (at 4 ohms)
100 Hz
53
0.10%
50-l 5,000 Hz 3
178 50 153 mm
Mass:
Power Requirement (neg. gmd.):
Operating Temperature:
Supplied Accessories:
7 2 6 in.
Approx. 1.4 kg (3.0 lb.)
12 V DC car battery
15°F to
-10°C to 50°C
l
l
l
Mounting Hardware
DIN Sleeve
l
Owner’s Manual English, French, Spanish and Portuguese