31
Kopenhagen RCR 45
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Adjusting the TIM standby
mode/TIM time
The TIM-TIME to be set corresponds to the
planned departure time. TIM will then be
active 1.5 hours before and after this adju-
sted time, so that the traffic messages will be
recorded during a period of three hours.
Note: During this period, a motor antenna will
remain extracted. Please take into account
the warning note of the end of this chapter.
1.5 hours
The motor antenna
will be extracted
start
adjusted
TIM-TIME
end
1.5 hours
•
Use the rocker button / to choose
“TIM-TIME” in the DSC menu.
•
Press << or >> to call up the adjusted
time.
If “TIM OFF” is displayed, the TIM
function is deactivated. “TIM OFF” is
between the time settings 23:00 and
0:00 hours.
•
Use the rocker button / to set the
time.
•
Use << to move to the hours or >> to
adjust the minutes.
Confirm your entry by
•
press the TIM button briefly.
The TIM-TIME is stored.
TIM will be active 1.5 hours before and after
the adjusted TIM-TIME.
Also, TIM will automatically stay on standby
for three hours after the radio was turned off.
When TIM is activated, the display will briefly
show “TIM ON” when the set is switched off.
Deactivating the TIM standby
mode
•
Press DSC with the radio being turned
on.
•
Use the / rocker button to select the
item “TIM TIME”.
•
Use << to move to the hours or >> to
adjust the minutes.
•
Switch to “TIM OFF” with rocker button
/ (you find this item between the
time settings for 23:00 and 0:00).
When TIM OFF is flashing,
•
press the TIM button briefly.
If the motor antenna is retracted immediately
after selecting TIM OFF, you can be assured
that the TIM function is deactivated.
TIM standby mode when the
radio is turned off
With this system it is possible to record inco-
ming traffic announcements automatically at
pre-determined times when the radio is tur-
ned off.
You may then recall such messages as des-
cribed above.
If you press TIM while a traffic announce-
ment is being played (TA lit up in the display),
the recording will be interrupted. When pres-
sing TIM once again, you will hear the mes-
sage text recorded until that interruption.
Setting the time in the DSC
menu:
TIM needs the exact time in order to operate
precisely. The time also has to be re-adjusted
after every interruption of the power supply.
•
Press DSC and the time will be display-
ed.
•
Press << to set the hours or >> to ad-
just the minutes.
The corresponding value is flashing.
To change the setting,
•
press the rocker button / .
To confirm your entry,
•
press the TIM button briefly.