Blaupunkt Denver CD147, Запись владельца, Страница: 13 / 20

13
Instructions — General Operation
See Traffic Safety & Precautions on page 4.
“Press” means a momentary press of less than 1/2 second. All presses requiring more than 1/2
second are followed by beep. (Beep for all button presses available through Direct Software
Control Menu.)
“Time Out” When additional button presses are anticipated to complete a procedure, the unit will
automatically exit the procedure after 4 seconds of inactivity. (8 for Menu mode.)
Ignition-Off Clock Recall
Any button press while ignition off displays time for 8 seconds.
Ignition-On
Unit lights up and clock is displayed.
Demo Mode
The unit is programmed to scroll some key features across the display if no button is
pressed for one minute . (You may have seen this at the store where you purchased your
radio.) TO TURN THIS OFF, turn the unit on and press DIS for 8 seconds until “DEMO OFF”
appears. (Pressing DIS for 8 seconds again will re-activate this feature.)
Release for Detachable Faceplate
Push REL to detach face. Already-inserted CD remains in unit. Current settings and source mode
are stored, except when detach occurs during Menu mode, new Menu settings are not stored. If
power was not switched off before face removed, unit will automatically power-on when face is
reattached.
Power (PWR) On/Off
When ignition on, press PWR or insert a disc to turn unit on. Last-used source becomes active,
unless unit is turned on by inserting disc, in which case CD player becomes active. Display
sequence at Power-On:
1. Turn-On Message (To turn message off or modify message, see Menu, page 19.)
2. “RADIO”, “CD PLAY” or “AUX IN”.
3. Functional information sequence (See Display Options, below.)
4. Priority display for active source.
Display Options
Press DIS to change information shown at times when no manual or automatic activity takes place.
Choice of priority display is separate for each audio source:
Radio: Station Name (if named) —> Frequency —> Clock
CD:
Track No./Elapsed Play Time —> Clock
AUX: “AUX IN” - Clock
After a change in source, radio station or CD play, the current source’s non-clock displays are
shown in sequence, then display returns to current source’s priority display.
Source (SRC)
Use SRC to select source - radio or CD (if already inserted) and/or auxiliary input (even if no input
on aux in line) as per model’s features.
Power Off
Press PWR for more than 1/2 second to turn unit off. Unit stores current settings for source,
station or track, etc. Antenna and amplifier trigger wires shut off voltage. (If faceplate still attached,
display switches to clock.)