ACM 3250 GB
20
Receiving traffic programme stations with RDS-EON
To switch the priority on or off:
•
Press the TA button.
When pressing TA while a message is being
broadcast, this message will be interrupted.
The unit will then switch back to the previous
condition. The priority for other traffic mes-
sages remains active.
Warning beep
If you leave the reception area of the traffic
programme station currently tuned into, you
will hear a warning beep after approximately
30 seconds.
This alarm tone will also be released when
pressing a preset button which has no traffic
programme allocated to it.
Switching the warning beep off
a) Tune into another station offering traffic
information:
•
Press
or
•
press one of the preset buttons 1-6
and tune into a stored traffic pro-
gramme station.
Alternatively:
b) Switch off the priority for traffic an-
nouncements:
•
Press TA.
“TA” will disappear from the display.
Many FM broadcasters offer traffic mess-
ages for their service area at regular inter-
vals.
All traffic programme stations transmit a spe-
cial carrier signal alongside their program-
mes, which is decoded by your car radio. If
this signal is identified, “TP” will appear in the
display (Traffic Programme).
In addition to these, there are also stations
which do not actually transmit traffic pro-
grammes themselves, but by using RDS-
EON they offer the possibility to receive the
traffic messages broadcast by another traffic
programme station in the same radio net-
work. If you listen to one of these stations
(e.g. NDR3), “TP” will appear in the display
as soon as the priority for traffic programme
stations has been activated, i.e. “TA” must be
displayed.
If a traffic announcement is broadcast, the
radio will automatically switch to the linked
traffic programme station (in this case,
NDR2) for the duration of the message and
return to the original programme (NDR3)
afterwards.
Traffic announcement priority
on/off
If the priority for traffic announcement pro-
grammes is activated, “TA” will light up in the
display.
Recalling stored stations
You can recall any stored station at the touch
of a button.
•
Select the memory bank by toggling the
FM button until the desired level ap-
pears in the display.
•
Press the corresponding preset button
until the display shows the desired pre-
set button.