Limb Set Up
Adjust for static alignment as shown in the ESK+ fitting instructions supplied with the module.
Cushion Valve adjustment - If after programming for the first time, the user experiences too much or too little damping at the end of the swing, the cushion valve may be
adjusted. Fine Tuning MUST always follow any cushion valve adjustment.
Smart IP operation
Smart IP operation
END
User Fine Tuning
(repeat
‘
Prosthetist Fine Tuning
’
)
EN
HOLD
Fully
extend
Flex to greater than 40
°
Save & Exit
x2
40
° +
4 secs
vary speed gradually for approx. 200 steps
refrain from sitting during programming
x2
x2
2 secs
Walk at various speeds to ensure user
is completely satisfied.
START
Save & Exit
x2
Calibrate Limb
& enter Program mode
Programming
vary speed gradually for approx. 200 steps
refrain from sitting during programming
Calibrate Limb to User
& enter Program mode
Programming
vary speed gradually for approx. 200 steps
refrain from sitting during programming
Fully
extend
Fully
extend
Fully
extend
Fully
extend
x3
HOLD
2 secs
Fully
Fully
Fully
Fully
Fully
extend
Fully
Fully
extend
Fully
extend
HOLD
x2
2 secs
Fully
extend
Fully
extend
Fully
extend
Fully
extend
x3
HOLD
2 secs
Fully
Fully
Fully
Fully
Fully
extend
Fully
Fully
extend
Fully
extend
HOLD
x2
2 secs
x1
UNTIL
vary speed gradually for approx. 200 steps
refrain from sitting during programming
HOLD
Fully
extend
Flex more than 40
°
Save
& Exit
x2
4 secs
HOLD
Fully
extend
Flex more than 40
°
Save
& Exit
x2
4 secs
Prosthetist Fine Tuning
STOP
Approx. 12m (40
’
) required
START
START
vary speed gradually for approx. 200 steps
refrain from sitting during programming
maximum 6 seconds
maximum 4 seconds
Limb Set Up
Adjust for static alignment as shown in the ESK+ fitting instructions supplied with the
module.
Cushion Valve adjustment - If after programming for the first time, the user experiences too
much or too little damping at the end of the swing, the cushion valve may be djusted. Fine
Tuning MUST always follow any cushion valve adjustment.
2
938250/4-0719
EN
