Blastrac 1-8DECMKI, Руководство по эксплуатации, Страница: 36 / 54

Operating Instructions 1-8DEC 230V
Wear Parts
8.1 Wear Parts
Certain portions of the blast unit are continuously exposed to high velocity abrasive.
These areas and their corresponding parts must be periodically inspected for wear and
erosion to keep from damaging components that are not normally exposed to the
abrasive blast. These parts are identified on the service drawings later in this manual
along with part numbers. Maintenance personnel design all parts for relatively easy
replacement. A preventive maintenance program should be performed to monitor these
areas on a regular basis. The following list outlines these areas and the time intervals
involved.
Wear Parts Chart
Part Inspection
Interval
Wear Indication Replacement
Method
Blast Wheel 5 Hrs.
Blades Worn by more
than 50%
Remove hub bolt and
replace
Feed Spout 50 Hrs. Thin at Wheel Entry Remove and replace
Control Cage 5 Hrs. Eroded Edges
Remove and replace;
adjust pattern
Rebound
Chamber
50 Hrs.
Thin Sections;
Wear on Welds.
Contact Blastrac
Service Center
Abrasive
Hopper
20 Hrs.
Thin Sections;
Wear at Welds;
warpage
Contact Blastrac
Service Center
Liners 15 Hrs.
Thin Sections;
Warpage; Holes
Loosen bolts, remove
and replace
Blast Wheel
Hub
Blast Wheel
Replacement
Abrasive wear; pins
missing
Remove and replace
Wheel Drive
Belts
Blast Wheel
Replacement
Wear spots; Thin
sections
Loosen motor
mounting bolts,
Loosen belt
tensioners, Remove
belts and replace
Keep in mind that other portions of the machine require periodic inspections and
maintenance. The parts mentioned above are associated with the internal abrasive
blast. Electrical cable and exhaust hose, for example, also require close inspection and
maintenance.
35