1
BLK-CPD207VH_CQ
9/26/12
Protective Sheet
PUSH
PUSH
2.
Using the base assembly as a template, mark the locations for the mounting screws (2) and the hole
for the drop cable on the mounting surface. Note that the drop cable can be routed through a cable
channel in the base and exit on the side of the camera assembly. The camera can be mounted on a
ceiling or wall.
Screw
Hole for
drop cable
3.
Select the best fasteners to secure the camera to the surface on which it will to be mounted. Screws
provided with the camera are adequate many surface types.
4.
Drill holes in the mounting surface as required for the mounting screws (wall inserts, etc.), and the
drop cable, if needed.
5.
Carefully route the camera drop cable through the drop cable hole or the cable channel in the base,
then attach the camera to the mounting surface.
6.
Route a video / power extension cable between your monitoring equipment and the camera. Note
that the extension cable connectors are usually different at each end.
7.
Connect the video / power extension cable to your camera, then connect the other end to a video
monitor and 12 Vdc or 24 Vac power source.
NOTE
: 1) The camera power cable provides a 2-pin
connector; an adapter with screw-down terminals is included in the box. 2) If powering the camera
with 12 Vdc, observe the polarity marked on the power drop cable.
12 Vdc polarity guide
Video drop cable
Terminal adapter
Power drop cable
8.
Verify that you can see video from your camera at the monitoring equipment.
NOTE
: An external video connector is provided on the camera module. See “Maintenance board”
on page 2. The adapter cable provided with your camera offers composite video through an RCA
connector to a local monitor.
BLK-CPD207VH 650 Line Indoor
IR Camera Quick Installation Guide
This document guides you through the basic steps to install and use your BLK-CPD207VH camera. The
camera includes 2.8-12 mm lens, OSD setup menus, and 12 Vdc or 24 Vac powering.
Camera features include:
•
650 TV-line resolution in color, 720 TVL B / W
•
Advanced Gen V DSP
•
Smart DNR technology efficiently reduces noise
in low light conditions
•
75 foot range with Smart IR 24-LED IR LED array
•
3-axis camera gimbal - mountable on ceiling,
wall or sloped surface
•
Day & Night function (ICR)
•
Support up to 8 privacy zones
•
Digital Wide Dynamic Range (DWDR)
•
Multi function : High Light Mask, Lens Shading
Compensation, Smart Motion Detection
•
Smart IR technology greatly improves camera
image in B / W mode when the IR LED array is on
•
Multi-language full OSD support
Camera
module
Drop
cable
Dome
Base
Seal
Precautions
•
Do not install the camera outdoors.
•
Do not install the camera in locations subject to moisture or vibration.
•
Do not scratch the camera, especially lens or dome cover.
•
Operate the camera within the specified temperature range 14
°
F ~ 122
°
F (-10
°
C ~ 50
°
C).
•
Handle with care. Dropping it can cause serious damage to the camera.
•
Do not install the camera in locations where direct sunlight shines onto or be reflected onto the lens.
•
Use a 12 Vdc, 1A regulated power adapter, or 24 Vac power adaptor.
Installation
1.
Remove the camera dome by pressing on the PUSH marks, then lifting the dome off the base. See
below. Do not remove the protective sheet at this time.
