SUKHOI 31.
Instruction Manual
6
INSTALLING THE AILERON
LINKAGES.
1. Working with the aileron linkage for
now, thread one clevis onto one of the
threaded wires.
4. Locate one nylon servo arm, and using
wire cutters,remove all but one of the arms.
Using a 2mm drill bit, enlarge the third hole
out from the center of the arm to accommo-
date the aileron pushrod wire.
5. Using pliers, carefully make a 90 degree
bend down at the mark made. Cut off the ex-
cess wire, leaving about 4mm beyond the
bend.
6. Insert the 90 degree bend down through
the hole in the servo arm. Install one nylon
snap keeper over the wire to secure it to the
arm. Install the servo arm retaining screw and
remove the masking tape from the aileron.
2. Attach the clevis to the outer hole in the
control horn.
3. Plug the aileron servo into the receiver
and center the servo. Install the servo arm onto
the servo. The servo arm should be perpen-
dicular to the servo and point toward the mid-
dle of the wing.
Repeat the procedure for the other wing
half
.
JOINING THE WING HALVES.
1. Locate the aluminium wing dihedral
brace.
2. Using a modeling knife, remove the cov-
ering wing.
C/A glue.
C/A glue.
Top side.
Bottom side.
M2 lock nut.
M2 clevis.
Snap keeper.
Содержание SUKHOI 31 BH11
Страница 27: ...SUKHOI 31 INSTRUCTION MANUAL 27...
