Black Horce Model JU87-STUKA BH80, Инструкция по эксплуатации

Страница: 23 / 36

23
JU87-STUKA -
Item code: BH80
.
Instruction Manual
C/A glue
 6. After the epoxy has fully cured, remove
the masking tape or T-pins used to hold the
stabilizer in place and carefully inspect the
glue joints. Use more epoxy to fill in any
gaps that were not filled previously and
clean up the excess using a paper towel and
rubbing alcohol.
Check to mark sure the wing and stabi-
lizer are paralell. If they are not, lightly sand
the opening in the fuselage for the stabilizer
until the stabilizer is paralell to the wing.
 Elevator and rudder pushrod install as same
as the way of aileron pushrod.
ELEVATOR AND RUDDER PUSHROD
INSTALLATION.
C/A glue
Remove
covering.