EDGE 540-V3 30cc Item code: BH94
.
Instruction Manual
3
necessary. If the air or the iron is too hot, the film
may melt and holes may be formed.
This model is highly pre-fabricated and can be built
in a very short time. However, the work which you
have to carry out is important and must be done
carefully. The model will only be strong and fly well
if you complete your tasks competently - so please
work slowly and accurately.
When self-tapping screws have to be screwed
into wood, apply a little white glue to prevent
them shaking loose: just squirt white glue into
the hole and fit the screw.
Caution:
This model is not a toy!
If you are a beginner to this type of powered model,
please ask an experienced model flyer for help
and support. If you attempt to operate the model
without knowing what you are doing you could
easily injure yourself or somebody else. Please
keep your safety and well-being in mind at all times.
Important:
Before you start construction
Even if you have built a large number of RC models
please read right through these instructions and
check all the kit components against the parts list.
We have taken great trouble to keep construction
as simple as possible, without making any
compromises in the area of safety.
Note regarding the film covering
Minor creases or bubbles may develop in the
film covering due to major fluctuations in weather
conditions (temperature, humidity etc.); in rare
cases you may even find a slight warp in a
component. These minor faults are in the nature of
film-covered built-up wooden structures, and can
easily be corrected using a heat gun, as commonly
used for modelling.
Creases:
Blow warm air over the area and
rub down with a soft cloth.
Wing warp:
Hold the panel twisted gently
in the opposite direction to the
warp, and apply warm air to
remove the creases from the
covering.
Caution! do not heat the film more than is absolutely
+ This is not a toy.
+ Be sure that no other flyers are using your radio
frequency.
+ Do not smoke near fuel.
+ Store fuel in a cool, dry place, away from children
and pets.
+ Wear safety glasses.
+The glow plug clip must be securely attached to
the glow plug.
+ Do not flip the propeller with your fingers.
+ Keep loose clothing and wires away from the
propeller.
+ Do not start the engine if people are near. Do
not stand in line with the side of the propeller.
+ Make engine adjustments from behind the
propeller only. Do not reach around the spinning
propeller.
SAFETY PRECAUTION
REPLACEMENT LARGE PARTS
K.
B.
E.
D.
G.
F.
C.
B.
D.
A. Cowling.
B. Wing panel (left & right).
C. Fuselage.
F. Aluminium wing dihedral brace.
D. Horizontal
stabilizer.
E. Vertical stabilizer.
G. Decal sheet.
K. Pilot.
A.
