Black+Decker STC5433PC, Руководство пользователя

Страница: 9 / 16

8
ENGLISH (Original instructions)
9
ENGLISH (Original instructions)
u
If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Labels on appliance
The following warning symbols are found on the appliance
along with the date code:
Wear safety glasses or goggles when operating
this appliance.
Wear suitable ear protectors when operating
this appliance.
Always remove the battery from the appliance
before performing any cleaning or maintenance.
Do not expose the appliance to rain or high
humidity.
Directive 2000/14/EC guaranteed sound power.
Features
This appliance includes some or all of the following features.
1. Trigger
2. Lock off button
3. Handle
4. POWERCOMMAND button
5. Speed-control switch
6. Auxiliary handle
7. Upper trimmer pole
8. Lower trimmer pole
9. Pole bracket
10. Head rotate button
11. Trimmer head
12. Edge guide
13. Guard
14. Spool housing
15. Dualvolt battery pack (Only with STC5433PC unit).
16. Charger (Only with STC5433PC unit).
Assembly
Warning! To reduce the risk of serious personal injury, turn
unit off and remove the battery pack before making any
adjustments or removing/installing attachments or
accessories. An accidental start-up can cause injury.
Assembly tools required
u
Phillips Screwdriver (not supplied).
u
Hex wrench (supplied).
Installing the guard
Warning! Never operate appliance without the guard (13)
firmly in place. The guard must always be properly attached
on the appliance to protect the user.
u
Remove the screw from the guard.
u
Turn the trimmer upside down so that you are looking
down at the spool cap ( 21 ).
u
Turn the guard ( 13 ) upside down and slide it fully onto
the trimmer head ( 11 ). Make sure the tabs ( 17 ) on
the guard engage the ribs ( 18 ) on the trimmer head as
shown.
u
Continue to slide the guard on until you hear it “snap”
into place. The locking tab ( 19 ) should snap into the
housing slot ( 20 ) as shown in figure G.
u
Using a phillips screwdriver, insert the guard screw and
tighten securely as shown in figure H to complete the
guard assembly.
u
Once the guard is installed, remove the covering from
the line cut-off blade, located on the edge of the guard.
Assembling the Pole
u
To assemble the pole, line up the upper trimmer pole
( 7 ) and the lower trimmer pole ( 8 ) as shown in figure I.
Press down the latching button ( 21 ) and slide the upper
pole into the lower pole. Ensure the latching button
engages the latch hole ( 22 ).
u
Secure the poles by tightening the middle bolt ( 23 ) with
the supplied hex wrench ( 24 ) as shown in figure J.
Attaching the auxiliary handle
u
Place the auxiliary handle ( 6 ) onto the top of the upper
trimmer pole ( 7 ) as shown in figure K.
u
Slide the bracket ( 25 ) of the auxiliary handle onto the
bottom of the handle.
u
Thread the handle bolts ( 26 ) through the handle and
into the bracket from above.
u
Tighten the handle bolts. Ensure the handle is securely
attached by closing the handle clamp ( 27 ).
u
To adjust the position of the auxiliary handle, open the
handle clamp and slide the handle up and down the
pole until it is in the desired location. Close the clamp to
lock the handle in place.
96