Note:
• The tractors have different pump models that operate differently.
Thus, when you connect the system to the tractor you use, you
must do more detailed testing and set the parameters correctly.
More specific information about the parameters, the alarm
messages and the troubleshooting instructions are in the CTR101
or CTR201 Operation manual.
3. Activate the driving function.
4. Start driving slowly:
a. Monitor the measured tractive power level.
b. Change between the set tractive power levels during the drive.
c. The measured value on the display decreases and increases with the level
change.
d. If the measured value does stay clearly below the 100 % when you use the
maximum tractive power level, decrease the value of the parameter
Maximum pressure level [bar].
Note:
The measured values can be different from the selected levels. This is
usual for low tractive power levels.
5. Change to freewheeling during driving. The motors make a short, approximately 1
- 3 seconds, rattling sound. Constant noise from the motors during freewheeling
is not permitted.
6. Only HDC: Do the HDC function test with different set levels.
Installation and commissioning
Product manual
33
