Black Box SW545A, Руководство пользователя, Страница: 34 / 64

35
CHAPTER 5: Configuration
• The Logoff Character should only be redefined when the default
Logoff Sequence is not compatible with your application.
• The disconnect sequence is not used when performing a Third-Party
Disconnection. The /D command is used to initiate a Third-Party
Disconnection.
9. Disconnect : Enable or disable the Logoff Sequence (“SEQ:”) and/or
Timeout Disconnection (“TIMEOUT:”) for this port. Be aware that if
you disable both the Logoff Sequence and the Timeout Disconnection
for a port, the only way to terminate any connection made to the port
will be to either:
a) Send a Logoff Sequence or wait for a Timeout Disconnection at
the port at the other end of the connection, or
b) Initiate a Third-Party Disconnection from a third port with “All”
command capability.
10. Timeout: Select the Timeout Period for this port. When Timeout
Disconnection is enabled for this port, and the port does not receive or
transmit data for the specified Timeout Period, the port will disconnect
from the associated port. You can choose 1, 5, 15, or 30 seconds or
1, 5, 15, or 30 minutes as the Timeout Period.
11. Message Type: Define the type of response messages that will be sent
when the PM Switch responds to commands. You can select Verbose
Messages (English-text response), Terse Messages (numeric/ abbreviated
response), or Quiet Mode (no response).
12. Echo: Enable or disable command echo (that is, choose the duplex
setting). If command echo is enabled (full duplex), commands sent to
the PM Switch will be echoed back to the sending device. If command
echo is disabled (half-duplex, the default setting), commands will not be
echoed.