27
CHAPTER 3: Installation
3.2.6 C
HANGING THE
K
EYBOARD
S
ETTING OF
W
INDOWS
NT 4.0 CPU
S
If any CPUs attached to your ServSwitch Ultra are running Microsoft
Windows NT 4.0, you
must
change the keyboard setting in their Control Panel from
the default, “Microsoft Enhanced Keyboard,” to “Standard 101/102 or Microsoft
Natural Keyboard.” Your ServSwitch system
will not work with these CPUs
unless their
keyboard settings are changed. To do this, take these steps:
1. Click on the icon for “My Computer” (or whatever you’ve named the
computer itself).
2. Click on “Control Panels.”
3. Click on “Keyboard.”
4. Click on the “General” tab.
5. In the Keyboard Type field, scroll from the “Enhanced” setting to the
“Standard” setting.
For more information, consult your Windows NT manual.
3.2.7 S
WITCHING FROM THE
K
EYBOARD
Your ServSwitch Ultra is now ready for operation using its default settings. To take
full advantage of the Switch’s features, refer to
Chapter 4
, which gives detailed
information about each of the ServSwitch Ultra commands, describing each
command’s function and keystroke sequence. For your convenience, this info is
summarized in
Section 4.2
. To begin switching immediately, however, just press
and release your keyboard’s left Control key ([Ctrl] or [control]), then—within
the next two seconds—type in your desired port number with the regular number
keys (not the numeric keypad). (This procedure is slightly more complicated if
there are more than nine CPUs in your Switch system; refer to
Section 4.3.1
.)