Black Box Power View PS570A, Инструкция по установке и эксплуатации, Страница: 28 / 32

Appendices
Appendix A: Resetting to Factory Defaults
You may reset the non-volatile RAM that stores all configurable options. This clears all administrator-
editable fields and resets all command line configurable options to their default values, including all
user accounts.
You may reset the unit to factory defaults from the HTML interface, the command line or by pressing
the reset button. You must have administrator-level privileges to issue the command. Using the reset
button may be necessary when a forgotten password prevents administrator login. Each of the methods
update the current working configuration to the factory defaults.
NOTE: Resetting the unit to factory defaults resets all TCP/IP and Web configurations. Reconfiguring of the TCP/IP and
Web settings will be required.
To reset to factory defaults from the HTML interface
On the Restart page in the Tools section of the HTML interface, select Restart and reset to factory
defaults from the drop-down menu and press Apply .
To reset the to factory defaults from the command line
At the Power View Enhanced PDU: prompt, type restart factory and press Enter .
To reset to factory defaults using the reset button
Press and hold the reset button between ten and fifteen seconds.
NOTE: If the reset button is depressed and held for more than 15 seconds, the reset will abort.
Appendix B: Uploading Firmware
You may upload new versions of firmware using File Transfer Protocol (FTP). This allows access to new
firmware releases for firmware improvements and new features additions.
NOTE: To begin an FTP upload session, you must first configure the FTP Host address, username/password, filename and
filepath. For information on configuring the FTP settings required for firmware upload see Chapter 3: Operations.
You may initiate an FTP upload session from the HTML interface or the command line. You must
have administrator-level privileges to initiate an upload.
To initiate an FTP upload session
On the Restart page in the Tools section of the HTML interface, select Restart and upload firmware
via FTP from the drop-down menu and press Apply .
Upon issuing this command the unit will restart and upload the firmware file specified with the FTP
Filename command from the previously configured FTP Host. See
FTP Administration in Chapter 3:
for more information.
To initiate an FTP upload session from the command line
The Restart FTPLoad command initiates an upload of firmware. Upon issuing this command the Power
View will restart and upload the firmware file specified with the FTP Filename command from the
previously configured FTP Host. See
FTP Administration in Chapter 3: for more information.
To initiate an FTP firmware upload session:
At the Power View Enhanced PDU: prompt, type restart ftpload and press Enter .
24
•
Appendices Power View Enhanced PDU
Resetting to Factory Defaults Installation and Operations Manual