Black Box Power View PS570A, Инструкция по установке и эксплуатации, Страница: 25 / 32

Displaying network configuration information
The Show Network command displays TCP/IP and Web configuration information.
•
NIC module serial number, MAC address and hardware revision code
•
IP address, subnet mask and gateway
•
Enabled-disabled status of Telnet support
•
Telnet and HTTP port numbers
•
HTTP authentication method
•
Network link status, connection speed and duplex value
To display network configuration information:
At the Power View Enhanced PDU: prompt, type show network and press Enter .
Example
The following command displays the network configuration information:
Power View Enhanced PDU: show network<Enter>
Network Configuration
NIC S/N : 1600001
MAC Address: 00-0a-9c-10-00-01
H/W Rev Code: 0
IP Address: 12.34.56.78
Subnet Mask: 255.0.0.0
Gateway: 12.34.56.1
Telnet: Enabled Port: 23
HTTP Port: 80 Security: Basic
Network Status
Link: Up
Speed: 100 Mbps
Duplex: Half
FTP Administration
The following commands are used to configure the Power View Enhanced PDU for an FTP firmware
upload. See Appendix B: Uploading Firmware for more information on initiating a FTP firmware upload.
Setting the FTP Host IP address
The Set FTP Host command sets the FTP host IP address allowing for firmware file uploads.
To set the FTP Host IP address:
At the Power View Enhanced PDU: prompt, type set ftp host , followed by the Host IP address and press
Enter .
Example
The following command sets the FTP Host IP address to 12.34.56.99:
Power View Enhanced PDU: set ftp host 12.34.56.99<Enter>
Setting the FTP username
The FTP Username command sets the username as required by the FTP Host.
To set the FTP username:
At the Power View Enhanced PDU: prompt, type set ftp username , followed by the FTP username and
press Enter .
Example
The following command sets the FTP username to Guest:
Power View Enhanced PDU: set ftp username guest<Enter>
Power View Enhanced PDU Operations
•
21
Installation and Operations Manual