Black Box Power View PS570A, Инструкция по установке и эксплуатации, Страница: 11 / 32

Mounting
1. Select the appropriate bracket mounting points for proper mounting depth within the rack.
2. Attach the brackets to these mounting points with two screws for each bracket.
3. Install the enclosure into your rack, using the slots in each bracket. The slots allow about ¼ inch
of horizontal adaptability to align with the mounting holes of your rack.
Connecting to the Power Source
Connect the female end of the power cord firmly into the connector, use a screwdriver to tighten the
screws on the retention bracket and plug the male end of the power cord into the AC power source.
Connecting Devices
To avoid the possibility of noise due to arcing:
1. Keep the device’s on/off switch in the off position until after it is properly attached to the outlets,
or
Log in to the Power View and turn the outlets off before connecting the devices to the unit(s).
2. Connect devices to the outlets.
Always disconnect the power supply cord before opening to avoid electrical shock.
Afin d’éviter les chocs électriques, débranchez le cable électrique avant d’ouvrir.
Immer Netzleitung auskuppeln vor den Aufmachen um elektrischen Schlag zu vermeiden.
Connecting to the Power View
Console (RS232) port
The Power View is equipped with an RJ45 Console RS-232 port for attachment to a PC or networked
terminal server. See
Data Connections in Appendix C: Technical Specifications for more information
on the Console RS-232 port.
Ethernet port
The Power View is equipped with an RJ45 10/100Base-T Ethernet port for attachment to an existing
network. This connection allows access to the Power View via Telnet or HTML.
The Power View is configured with the following network defaults to allow unit configuration out-of-
the-box through either Telnet or HTML:
•
IP address: 192.168.1.254
•
Subnet Mask: 255.255.255.0
•
Gateway: 192.168.1.1
The local PC network connection must be configured as noted below:
NOTE: Contact your system administrator for instructions in reconfiguring the network connection. Reconfiguration of
your network connection may require a restart to take effect.
•
IP address: 192.168.1.x (where x is 2-253)
•
Subnet Mask: 255.255.255.0
Power View Enhanced PDU Installation
•
7
Installation and Operations Manual