20
HPIIISi TWINAX CARD
5.3 The Commands In Detail
This section describes each of the host-download commands, including all
available arguments (options). (Any argument that represents a factory-
default value is marked with an asterisk.) Examples are also included for each
command.
Command:
00, Twinax Address
Description:
Determines the Card’s address in your twinax network. New addresses don’t
become active until the printer is powered off and then on again. When you
set a new address, it remains in effect
permanently
until you specifically set the
address again—even restoring factory defaults doesn’t change this setting.
Possible Arguments:
Results:
0 to 6
Sets Card’s address (ships from the factory as *0).
Example:
“&%Z00,5” sets the Card’s twinax address to 5 after the next power-up.
Command:
01, Alternate CPT-Start Delimiter
Description:
Creates an alternate start delimiter for command pass-through, which is also
an alternate host/PC-download delimiter. It may be one or two characters
long; the first character may be any printable character other than “&”. The
Card only recognizes one alternate start delimiter at any given time, but it will
always recognize the primary CPT-start delimiter “&%” as valid even if an
alternative start delimiter has been defined.
Possible Arguments:
Results:
[Any two characters
Defines new alternate start delimiter.
that are not both
spaces]
[Two spaces]
Deletes previously defined alternate start delimiter.
Example:
“&%Z01,#*” designates “#*”as an additional start delimiter.
