10
24-PORT 10/100 MANAGED SWITCH WITH GIGABIT UPLINK PORT
3.3 Rackmounting
The switch can be mounted in an EIA standard-size 19" rack that can be placed in a
wiring closet with other equipment. Attach the mounting brackets at the switch’s
front panel (one on each side) and secure them with the eight provided screws.
Next, install the switch in the rack.
NOTE
The four screws used to connect the switch to the rack are
not
included;
you must supply them.
3.4 Install the Gigabit Uplink Module (Optional)
To connect to a Gigabit fiber link, slide the Gigabit Uplink Module (LGB2004C-
MMSX or LGB2004C-SMLX) into the slot on the switch’s front panel. See Figure
4-1 for the fiber module slot’s location.
3.5 Connecting Network Cable
The switch supports 10-Mbps Ethernet or 100-Mbps Fast Ethernet that runs both in
half- and full duplex mode.
These RJ-45 ports are auto-MDI. The switch can auto transform to MDI-II or
MDI-X, so you can make an easy connection without worrying if you are using a
standard or crossover RJ-45 cable.
If you installed an optional Gigabit uplink module (LGB2004C-MMSX or
LGB2004C-SMLX) in the switch’s Gigabit uplink module slot, you will need to
connect the fiber cable for this link. Use 1310-nm multimode or single-mode
fiberoptic cable.
3.6 Applying AC Power
The 24-Port 10/100 Managed Switch with Uplink Port uses a 100–240-VAC,
50–60-Hz power supply. Its power switch is located on the unit’s rear panel, next
to the AC power connector. The power supply automatically adjusts to the local
power source. Power on the unit without having LAN segment cables connected.
Содержание LGB2004A
Страница 3: ......