Black Box LE2700A, Руководство пользователя, Страница: 74 / 154

724-746-5500 | blackbox.com
Page 74
Chapter 5: Management
Table 5-40 (continued). QoS Egress Port DSCP Configuration screen options.
Label Description
Egress Port egress rewriting can be one of the following options:
Disable: no Egress rewrite
Enable: rewrite enabled without remapping
Remap DP Unaware: DSCP from the analyzer is remapped and the frame is remarked with a remapped DSCP
value. The remapped DSCP value is always taken from the ”DSCP Translation->Egress Remap DP0” table.
Remap DP Aware: DSCP from the analyzer is remapped and the frame is remarked with a remapped DSCP value.
Depending on the DP level of the frame, the remapped DSCP value is either taken from the 'DSCP Translation-
>Egress Remap DP0' table or from the “DSCP Translation->Egress Remap DP1” table.
5.6.5 Port Policing
This page allows you to configure Policer settings for all switch ports.
Figure 5-61. QoS Ingress Port Policers screen.
Table 5-41. QoS Ingress Port Policers screen options.
Label Description
Port The port number for which the configuration below applies.
Enable Check to enable the policer for individual switch ports.
Rate Configures the rate of each policer. The default value is 500. This value is restricted to 100 to 1000000 when the
Unit is kbps or fps, and is restricted to 1 to 3300 when the Unit is Mbps or kfps.
Unit Configures the unit of measurement for each policer rate as kbps, Mbps, fps, or kfps. The default value is kbps.
Flow
Control If Flow Control is enabled and the port is in Flow Control mode, then pause frames are sent instead of being
discarded.