Black Box LE2700A, Руководство пользователя, Страница: 124 / 154

724-746-5500 | blackbox.com
Page 124
Chapter 5: Management
Table 5-92. System Log Information screen options.
Label Description
ID The ID (>= 1) of the system log entry.
Level The level of the system log entry. The following level types are supported:
Info: provides general information
Warning: provides warning for abnormal operation
Error: provides error message
All: enables all levels
Time The time of the system log entry.
Message The MAC address of the switch.
Auto-refresh Check this box to enable an automatic refresh of the page at regular intervals.
Refresh Updates system log entries, starting from the current entry ID.
Clear Flushes all system log entries.
|<< Updates system log entries, starting from the first available entry ID
<< Updates system log entries, ending at the last entry currently displayed
>> Updates system log entries, starting from the last entry currently displayed.
>>| Updates system log entries, ending at the last available entry ID.
5.10.5 Cable Diagnostics
This page allows you to perform VeriPHY cable diagnostics.
Figure 5-115. VeriPHY Cable Diagnostics screen.
Press Start to run the diagnostics. This will take approximately 5 seconds. If all ports are selected, this can take approximately 15
seconds. When completed, the page refreshes automatically, and you can view the cable diagnostics results in the cable status
table. Note that VeriPHY diagnostics is only accurate for cables 7–140 meters long.
10 and 100 Mbps ports will be disconnected while running VeriPHY diagnostics. Therefore, running VeriPHY on a 10 or 100
Mbps management port will cause the switch to stop responding until VeriPHY is complete.