Black Box LBH2001A-H, Инструкция по установке и эксплуатации, Страница: 62 / 73

BLACK BOX
®
Gigabit Media Converter Switch Installation & User Guide
49
3.8.3 Connecting Fiber Optic SC-type, "Snap-In"
The following procedure applies to installations using SC-type fiber
connectors, i.e., using multi-mode SC. While connecting fiber media to SC
connectors, simply snap on the two square male connectors into the SC female
jacks of the Fiber connector until it clicks and secures.
3.8.4 Installing LC-type SFP module,“Small Form Pluggable (SFP)”
Grasp the SFP module by your thumb and forefinger. Insert the SFP into the
SFP slot. Apply a light pressure to the SFP until the device clicks and locks
into position. Now connect your LC connectors.
3.8.5 Connecting Single-Mode Fiber Optic
When using single-mode fiber cable, be sure to use single-mode fiber port
connectors. Single-mode fiber cable has a smaller diameter than multi-mode
fiber cable (9/125 microns for single-mode, 50/125 or 62.5/125 microns for
multi-mode where xx/xx are the diameters of the core and the core plus the
cladding respectively). Single-mode fiber allows full bandwidth at longer
distances, about 70km with the single-mode LC.
The same procedures as for single-mode fiber apply to multi-mode fiber
connectors. Follow the steps listed in Section 3.8.3 above.