Black Box LBH2001A-H, Инструкция по установке и эксплуатации, Страница: 61 / 73

BLACK BOX
®
Gigabit Media Converter Switch Installation & User Guide
48
1. Using standard twisted pair media, insert either end of the cable with a RJ-45
plug into the RJ-45 connector of the port. Note that, even though the connector is
shielded, either unshielded or shielded cables and wiring may be used.
2. Connect the other end of the cable to the corresponding device.
Use the LINK LED to ensure proper connectivity by noting that the LED will be
illuminated when the unit is powered and proper connection is established. If this
does not help, ensure that the cable is connected properly and that the device on
the other end is powered and is not defective.
For Port # 1 or 1SW, if the LINK LED is not illuminated, move the switch which
has a cross-over or up-link for linking to another hub or Switch.
3.8.2 Connecting Fiber Optic LC-type, “Small Form factor (SFF)”
The following procedure applies to installations using LC-type fiber
connectors, i.e., using LC single-mode. While connecting fiber media to LC
connectors, simply snap on the two square male connectors into the LC female
jacks of the Fiber connector until it clicks and secures.