Express Ethernet Switch
TX ports: assigned to V1, auto-negotiation, and flow control ON.
FX ports: assigned to V1, 100FX full-duplex, and flow control ON.
The console port menu displays the current settings (i.e.:
auto->100TX full
) or, if the port is not connected, displays
the message
auto->No Link.
Establishing a VLAN for LB9007A-ST-R2, LB9007A-SC-R2 & LB9012A
Virtual Local Area Networks (VLANs) enable segmenting of the LAN without regards to physical location. Assign
each port to a VLAN group or set of groups according to accessibility needs. Thus, a specific port could be in more
than one VLAN group. There are 4 VLAN groups available for models specified here.
The port numbers are designated alpha-numerically. The letters A, B, and C identify three slots from left to right and
the ports are numbered 1 through 4. Therefore, the port # is a combination of the slot (A-C) and the position of the
port in that section (1-4). LB9012A has 3 slots and LB9007A-SC/ST-R2 have 2 slots A & B only.
Follow these steps to assign port(s) to a VLAN group.
•
Enter
[V]
from the Main Menu
•
Select a VLAN group:
[V1]
,
[V2]
,
[V3],
or
[V4]
•
Enter the port #.
Note: If entering more than one port to a VLAN group, separate each port # by commas without spaces or dashes.
To enter an entire module, enter only the letter (A, B, or C).
Only one VLAN group can be defined at a time. Repeat selecting VLAN groups and assigning ports until all ports
are assigned to at least one VLAN group. Though each VLAN grouping does not need to be utilized, each port must
be assigned to at least one VLAN group. Hit the
[ESC]
key when done.
To return to the default settings (in which each port is assigned to V1), enter
[D]
from the main menu. A prompt
appears to verify this action.
VLAN Example
:
•
Enter
[V1]
(no [
ENTER]
)
•
Key A1,B4,C2
Proceed with the assignment of the remainder of the ports into any VLAN grouping:
•
Enter [
V2
] (no
[ENTER]
)
•
Key A1,B1,B2,B3,
•
Enter [
V3
] (no
[ENTER]
)
•
Key A2, A3, A4
Note: Until assigned, the menu displays **error** for each unassigned port. While any port is in the **error**
status, the [
ESC
] key will not return the screen to the main menu. Assign each port to a VLAN grouping prior to
exiting program.
View the results on the following illustration.
25
The current V1 is A1,A2,A3,A4,B1,B2,B3,B4,
Please enter the new port list ->
