Black Box KV101A, Руководство пользователя, Страница: 19 / 77

SERVSWITCH™ CONSOLE PLUS
18
STEPS: (See Figure 2 for an example of a single Unit installation)
(Refer to the troubleshooting section for help if needed)
1.
Connect a KVM station to the ServSwitch Console Plus DB25F, KVM
connector using the appropriate KVM cable.
2.
Turn on the KVM stations video monitor and the ServSwitch Console Plus.
(Wait for the internal diagnostic check to complete and fade out)
3.
Switch the KVM station to the CPU port being configured (starting with
CPU port #1). This is done by pressing and releasing the left control [Ctrl]
key and within 2 seconds, type in the CPU port # being configured
(starting with port 1) and press [Enter]. A connection dialog box will
display showing the connection status. (Figure 17)
(See Note below on switching methods)
4.
Pre-configure the CPU port, if needed, as outlined in steps 4a-e if the
computer being connected does not use a PC2 type keyboard or a PS/2
mouse (defaults). Pre-configure the CPU port before connecting the
computer. If the computer uses a PC2 type keyboard and PS/2 mouse,
connect it to the corresponding CPU port. No pre-configuration is
needed.
Pre-Configuration procedure
Call up the Configuration menu system by pressing and
releasing the left [Ctrl] key, then the [F12] key. (Figure 5)
a. Select “Computer” and press [Enter] (Figure 7)
b. Select the computer to change the default keyboard and/or mouse type,
and then select the keyboard or mouse field for the selected computer
and press [Enter]. A selection box will display, listing the supported
keyboard or mouse types.
c. Select the correct keyboard or mouse type for the selected computer
and press [Enter].
d. Press [ESC] to return to the “Main menu” and save the changes.
e. Connect the computer to the pre-configured CPU port.
5. Boot the computer the KVM station is connected to if the computer power
was off. You should see the boot up sequence on the KVM monitor. If the
computer was connected to a pre-configured CPU port with power applied,
you should see that computers video.
6. Verify that the keyboard, video, and mouse on the connected computer
function properly before proceeding.
7. Switch the KVM station to the next sequential CPU port as explained in
step 3 and perform steps 4-6 for that computer and for the remaining
computers.
NOTE: Switching CPU ports can also be performed by pressing the
“+ “ or “- “ select buttons on the front panel. “+” will switch to
the next sequential CPU port, “- “ will switch to the previous CPU
port. The connection dialog message will display after pressing
either button showing which CPU port is connected.