Black Box ET0010A, Руководство пользователя CLI, Страница: 44 / 212

Layer 2 Configuration
ETEP CLI User Guide 45
admin>
configure
config>
remote-interface
rem-if>
tx-enable follow-rx
rem-if> exit
config>
local-interface
loc-if>
tx-enable follow-rx
loc-if>
exit
config>
cli-inactivity-timer 0
config> exit
Layer 2 Configuration
Check the following settings when the ETEP is operating in a Layer 2 deployment:
●
Configure the IKE VLAN tag if you are deploying Layer 2 point-to-point policies in a network that
requires a specific VLAN tag for all Ethernet traffic. This feature is disabled by default.
●
Verify that transparent mode is enabled for Layer 2 policies (enabled by default)
Layer 2 configuration commands are available to the Admin user.
Assigning a VLAN Tag
When the ETEP is configured for operation with Layer 2 point-to-point policies, the two ETEPs must be
able to communicate with each other to exchange key information. In some Layer 2 networks, all frames
must have a VLAN tag to traverse the network. The ETEP can be configured to add a VLAN tag to the
Ethernet frames used for ETEP-to-ETEP communications.
This setting has no effect when the ETEP is configured for use in EncrypTight distributed key policies.
To assign a VLAN tag:
1 Enter remote configuration mode.
admin> configure
config> remote-interface
2 Configure the vlan-tag command. Attributes are described in Table 18 .
vlan-tag {enable [<tag-priority>] [<tag-id>]} | {disable}
Table 18 vlan-tag command description
Attribute Description
enable Enables the VLAN tag function.
disable Disables the VLAN tag function.This is the default.
tag-priority Sets the VLAN tag priority. Valid values range from 0–7. The default value is
0.
tag-id Sets the VLAN ID. Valid values range from 0–4094. The default value is 1.