Black Box ET0010A, Руководство пользователя CLI, Страница: 39 / 212

Configuring the ETEP
40 ETEP CLI User Guide
Setting the Date and Time
Setting the date and time on the ETEP helps ensure that the appliance’s time can be synchronized
properly with other ETEPs or components in the EncrypTight system.
The time zone on the ETEP is set to UTC 0 (Coordinated Universal Time), and is not user configurable.
Enter the date and time relative to UTC 0, also referred to as Greenwich Mean Time (GMT). To calculate
the local time relative to UTC, add or subtract the offset hours from UTC for the local time zone (UTC ±
n) . The following examples give the local time at various locations at 12:00 UTC when daylight saving
time is not in effect:
●
New York City, United States: UTC-5; 07:00
●
New Delhi, India: UTC+5:30; 17:30
To set the date and time:
1 At the command prompt, type
configure
to enter configuration mode.
2 At the
config>
prompt, type
date <year> <month> <day> <hour> <minutes>
<seconds>
3 Type
exit
to return to the command prompt.
Example
admin>
configure
config> date 2008 10 11 15 30 00
config> exit
Entering the Throughput License
The method for entering licenses on the ETEP depends on your management software:
●
For ETEPs that are managed exclusively through the command line, follow the procedure in this
section.
●
For EncrypTight deployments, throughput licenses must be managed with the EncrypTight software.
Licenses entered from the CLI are not recognized as valid in an EncrypTight deployment. See the
EncrypTight User Guide for more information.
year 2008-2037
month 01-12
day 01-31
hour 00-23
minutes 00-59
seconds 00-59