Black & Decker GR230C, Руководство пользователя

Страница: 5 / 16

5
ENGLISH
•
4 handle wing nuts.
•
4 washers.
•
2 bolts.
•
User manual including guarantee card.
•
Service sheet.
Handle assembly (Fig. B)
Remove all the parts from the carton and
familiarise yourself with the individual parts of
your mower.
With your mower body on a level surface,
assemble the lower handles to your mower
body as follows:
Note: The switch box should be positioned
on the right hand side of your mower when
viewed from the operating position. Ensure
that the electrical supply cables to and from
the switchbox are not damaged or twisted
before you begin to assemble your mower.
B1
•
Locate the lower handles (1) over the
grassflap axle (2) and position the flange
on the handles into the rectangular
aperture in the deck (3).
B2
•
Fit a plain washer (5) and then fit the
wing nut (6) onto the axle. The plain
washers and wing nuts can be found in
the parts pack. Tighten each wing nut
with hand pressure only.
B3
•
Place the upper handle (7) into the cups
of the lower handles and align the holes
in the upper and lower handles. Fit a bolt
(8) through each hole. Fit a plain washer
and then fit the wing nuts onto the bolts.
Tighten each one with hand pressure only.
Note: Do not use a spanner or other
implement to tighten the wing nuts.
Fit the switchbox to the upper handle
as follows:
B4
•
Remove the two screws holding the
retaining plate to the main body of
the switchbox.
B5
•
Locate the two pins on the switchbox
with the holes in the upper handle.
B6
•
Fit the retaining plate over the stem of the
handle using the two screws provided.
Note: Do not overtighten these screws -
light pressure will be sufficient to hold the
switchbox in position.
Wheel assembly and height of cut
adjustment (Fig. C)
Before wheel assembly adjustment ensure
your mower is disconnected from the mains.
Each of the four wheels has its own means
of height adjustment which gives 3 cutting
height positions.
C1
•
Select one of the holes in the mounting
plate (9) and note it as the other wheels
will have to be adjusted to the same
position.
•
Locate the wheel (10) and the screw bolt
(11) into the selected hole and ensure the
washer (12) is present on the bolt
between wheel and cutter deck.
•
Position nut (21) behind chosen hole in
the mounting plate.
C2
•
Use the spanner provided and turn the
screw bolt in a clockwise direction.
Ensure the wheel is free to rotate.
Using the same height adjustment position
repeat the procedure for each of the other
three wheels.
The bottom hole in the mounting plate will
give a maximum height of cut which is
suitable for coarse or overgrown grass. The
top hole should be used for maintaining
cultivated lawns, and the middle hole is for
intermediate conditions.
We recommend that the middle or bottom
hole is selected for the first use of your
lawnmower.
Grassbox assembly (Fig. D)
Read the safety instructions at the beginning
of this manual before using this accessory.
D1
•
The grassbox is supplied in two parts
which slot together.
Fitting the grassbox to your mower:
D2
•
The spring loaded rear flap (15) is lifted
and the top of the grassbox is placed
over the mounting.
•
The rear flap can now be released to lock
the grassbox into position.
Removing the grassboxfrom your mower:
The full grassbox may be removed by raising
the grassflap, freeing the grassbox from its
mounting and resting it on the lawn. The
grassflap can be gently lowered, leaving both
hands free to lift the full grassbox.