9
NOTICE:
THE COMBINATION OF FACTS, DATA, DESIGN ELEMENTS, ENGINEERING DATA, MANUFACTURING DATA & ASSEMBLY DATA
WHICH MAY BE CONTAINED IN THIS DOCUMENT ARE OF A PROPRIETARY NATURE TO BKI.
THESE MATERIALS ARE NOT TO BE USED OR COPIED WITHOUT PRIOR WRITTEN PERMISSION FROM BKI.
ALL RIGHTS ARE RESERVED.
Programming
IMPORTANT NOTES:
•
Make sure that the light on the program button stays on during programming.
•
Once the
Prog
button has been activated, hold function, program number selection &
adjustments to time & temperature must start within 5 seconds.
•
When the program values have been set the controller must be left for 8 seconds or the
Prog
button must be pressed and held within 5 seconds to save details into memory.
•
If the
Prog
light switches off before the changes have been saved the program reverts to its
original settings, and you will have to start again!
•
The
“Xtra Time”
button will only function if the
“Hold”
function has been programmed or the
oven is above the hold temperature.
Programming for Two-Stage Cooking
•
•
•
•
•
Press
Prog
button & hold until
Prog light
&
Cook button light
comes
“ON”
, then
release
button
.(the controller is now in programming mode)
While in the programming mode, the display shows the cook time & temperature for
Stage-2
.
Stage-1
of the two stage cook program has to be set using the Pre-Heat button, press
Pre-heat
(cook button light goes “out” & Pre-heat button light comes “on”)
Use
the Navigation keys to
set the first stage cook time and temperature settings.
If you wish to bypass Stage-1, set the cook time and temperature to zero.
Now press the
Cook
button, the settings for
Stage-2
appear in the display area.
Use
the Navigation keys to set the second stage cook time and temperature settings.
Remember, add the cook times of Stage-1 and Stage-2 to give the total cook time.
To program a Hold cycle, now press the
Hold
button, the settings for Hold Stage appear in the
display area.
Use
the Navigation keys to set the required Hold time and temperature settings.
Remember, The “Xtra Time” button will only function if the “Hold” function has been
programmed or the oven is above the hold temperature.
