bk ultrasound Flex Focus 1202, Руководство пользователя

Страница: 56 / 66

56 Chapter 5 December 2015 Flex Focus 1202 User Guide (BB1756-Q)
The blue diode starts blinking fast.
A dialog box appears on the monitor. This may take up to two minutes.
5
Click Accept to pair the system with the remote control (indicated by its serial
no.).
The pairing process takes up to one minute.
When pairing is done, the remote control emits a beep and the blue diode blinks
to show the remote control is awake.
NOTE:
The pairing process may time out. Try again if this happens.
NOTE:
If the cursor starts drifting on the monitor, place the remote control in its
holder and leave it for 30 seconds to recalibrate.
If you have more than one remote control, be sure you know which system each is
paired with; the system and remote control remain paired even if the remote control
is taken away to be disinfected. Pairing lasts until you pair the remote control with
another system or pair another remote control with the system. Therefore, it is
important to keep track of which remote control is paired with which system.
Before each use, verify that the remote control is working correctly.
Sleep
If the remote control is not used or moved for 5 minutes, it goes to sleep to save
battery power. To wake it up, press any key.
Mouse Function
You can use the remote control as an air-tracking mouse to operate controls on the
system monitor.
To move the cursor, tilt the remote control; that is, move the front end up, down, or
side-to-side. The mouse will not respond if you keep it level.
NOTE:
You do not need to point it at the monitor. The cursor responds to changes in
the position of the remote control, not to the position itself.
To select an object on the monitor, move the remote control so that the cursor is on
the object, then press
Select
.
Replacing Batteries
1
Remove the battery cap.
2
Insert 2 batteries LR6 size AA 1.5 volt.
3
Screw the battery cap on tight until the arrow points to the area
of the battery cap with a large gap between the ridges.
When the battery cap is screwed on tight, the remote control is
watertight and can be immersed.