Chapter 4
Meter Display
The 5335C has 3 configurable display formats. Each format also allows for 5 different configured sets of
measurement. 1 large and 6 small, 4 large and 6 small, or 12 small measurements may be displayed.
The power meter has three interface display styles for measurement of basic parameters. At most five pages are
displayed in each style. When one or more important measurement parameter(s) should be highlighted, the View1
or View4 mode can be freely enabled to design the humane display style. When you need to view all parameters at
the same time in one interface, the View12 mode can be enabled. Take power measurement as an example. The
interface can display four parameters in the large font form: effective voltage, effective current, active power and
power factor.
Figure 4.1: 1 main measurement
4.0.1
Operation steps
1.
In the “Meter” interface when the soft key corresponding to “VIEW 4” is pressed, 10 measurement
parameters can be displayed in total, 4 of which are displayed in an amplified manner. Other measurement
parameters can be viewed by pressing “VIEW” key to turn pages, as shown in the figure below.
2.
When the soft key corresponding to “CONFIG” is pressed, the measurement function can be selected and
the interface display information can be set.
3.
When the soft key corresponding to “FUNC” is pressed, the measurement function can be selected. For
example, when the “FUNC” key is pressed once, the displayed measurement function will be switched once
in the W/A/V sequence. Different measurement parameters are displayed when different functions are
selected. As power measurement is taken as an example in this operation, W is selected.
20
