BJ-237
Enabler 9R
User guide
This enabler with nine relay switched contacts is designed to
control up to 9 functions of the same element or of different
elements: lifts, ceiling hoists, elements in a sensory room,
etc.
Fig. 1: BJ Enabler 9R
You can activate the enabler remotely using any of the BJ
System’s remote controllers.
RF Frequency
433MHz
Power supply
12-24 Vdc / 12Vac
Output
9 relay contact
Size
105 x 59 x 36 mm.
Minimum section of the power
cables
0.5 mm2
Maximum section in load circuit
1.5 mm2
Maximum resistive loads:
1A - 24Vdc
1A - 24Vac
Not compatible with 230 V ac loads
For correct installation, the enabler must be fitted in a sealed
box that provides sufficient space, absence of dust and
humidity and isolation from direct contact with people.
The dimensions of the box where it is installed must be at
least: 120mm x 100mm x 48mm (length, width, height).
It can be fitted on the surface or recessed. The enabler
has two “anchoring holes” for fitting (Fig. 1). The distance
between the anchoring holes is 105mm and the holes’
diameter is 4mm.
To install the enabler you must carry the enabler’s power
cable and load cable’s to the box where it will be installed.
For a proper installation of the device see figure 2:
Fig. 2: Circuit diagram of the Enabler connections
IMPORTANT!:
See the device technical data to check
the type and maximum loads that can be connected
to the enabler.
Power cables must be stripped a distance of 5mm.
Once the enabler’s connections are made and before
connecting the device to the power supply, you must
choose the position on the “RF code selector” (see figure
1).
NO
C
NO
C
NO
C
NO
C
NO
C
NO
C
NO
C
NO
C
NO
C
1. Description of the Device
2. Technical data
3. Pre-installation
4. Installation
CAUTION!
Electrical installation may only be
carried out by a qualified electrician!
Do not make any unauthorized alterations or
modifications to the unit.
The relay contact is only suitable for
low voltage
power supply
(24 V dc/ac – 1A)
Observe the manufacturer’s instructions for the
device to be operated.
CAUTION!:
An error in the connections may cause
serious damage to the device or the installation,
or harm to the operator.
Power supply
terminal
Relay’s
terminal
Jumper
Anchoring
hole
RF code
selector
