BJ Live BJ CONTROL PRO, Руководство пользователя

Страница: 14 / 24

BJ-256 BJ Control Pro
User Guide
BJ-256 BJ Control Pro
Page 14
3.4 Macro programming with sequences of up to 7
consecutive actions
A macro is a series of actions performed sequentially in a set space of time. For
example: open the door to the building, turn on the hall light and call the lift. To
programme macros, follow steps 1, 2 and 3 for RF code recording. The next steps
to follow are explained below:
1. Choose the level you require
2. Select the programming mode on the remote
3. Choose the key you wish to programme
4. Enter code 700
In this step, you need to enter code 700. The battery LED will turn green and the
three level LEDs will light up.
5. Enter each code of the sequence
a) If you enter RF codes , remember that you must enter each one as a 3-digit
code. The level LEDs will flash after each code is entered.
b) To enter IR codes , follow the instructions in section 3.3: Choose the level
you require - Select the programming mode on the remote - Choose the key
you wish to program - Enter the code 000 – record the IR signal by facing
the original remote and the Control Pro IR port.
NOTE: Up to 7 codes (RF or IR) can be entered in each key.
6. End the sequence
To end the sequence, enter code 700. The battery LED and three level LEDs will
switch themselves off and the remote will return to standby mode.
To record a macro with numbers, for example “channel 17” in one cell: 1) Choose
the level you require. 2) Select the programming mode on the remote. 3) Choose
the key you wish to program. 4) Enter code 700. 5) Press 000, then first number in
the macro (1) Then 000 again and second number (7). Finish entering code 700.
IMPORTANT : Remember that you can only enter 7 codes for each key, including a
maximum of 7 IR codes.
NOTE : When the sequence is activated, there will be a 1-second time lag between the
actions.