RFID Programming Manual
Ver.01.10
- 6 -
3. RFID Printer Settings
After first installing the RFID label printer, make sure to perform the following steps 1~5.
1) RFID Transponder Selection
This step involves the selection of the RFID transponder type and entails the “>RFS”
command.
2) Read/Write Retries (Retry Number Coding) Setting
This step involves the setting of the number of retries to execute with an RFID label
when the initial writing of the RFID label fails, and entails the use of the “>RFS” or ”>RR”
command.
3) Number of Labels (Number of Labels Upon Retry) Setting
This step involves the setting of the number of labels for a retry when the initial writing of
the RFID label fails, and entails the use of the “>RFS” or ”>RR” command.
4) RF Send/Receive Power Setting
This step involves the setting of the sending/receiving power when reading or writing via
the R
FID transponder, and entails the use of the “>RFS” or “>RFP” command.
Ex.) >RFS,5,3,2,15
- 5: Transponder Type (5: GEN2)
- 3: Write/Read Retries
- 2: Number of Labels
- 15: Send/Receive Power (0~30, higher the number the higher the power)
5) RFID Label Coding Position (Read/Write Position of Transponder) Setting
When using an RFID label for the first time with the printer, to determine the optimal
position for RFID label coding (write/read), the automatic transponder position
calculation function of the printer can be used as follows.
- Use Command
(1) Insert the RFID label into the printer and turn on the printer power.
(2)
Do Media Calibration and then recognize the RFID Label(Tag).
(3) Send the
“>RFCP” command to the printer.
(4) When the p
rinter receives the “>RFCP” command, the optimal coding position is
automatically calculated and subsequently saved on the printer. The saved value
remains even when the printer is turned off, and is permanently stored.
