BITREK BI-530P TREK, Руководство по эксплуатации

Страница: 14 / 49

14
www.bitrek.com.ua
sales@bitrek.com.ua
+380 44 507 02 07
List of control commands to operate the device
Table 4 – List of control commands to operate the device
No. Command Description
Availability
of response
1 cpureset Reload of device processor no
2 rstallprof
Restoring of original state of profile
settings
no
3 deleterecords Deletion of all saved records no
4
setparam
####
Set the value of the parameter by ID yes
5 boot #,#,# Update of device software yes
6 setdigout ##
Set the mode of operation of digital
output Out 1
Yes
7 ignitionoff
Activation of the safety locking of
ignition
yes
8 ignitionon
Deactivation of the safety locking of
ignition
yes
Notes to Table 4.
Reboot of device processor.
Command to be send – cpureset;
No response is returned for this command. Receipt of the command
initiates a complete restart of all device processes.
Restoring of original state of profile settings.
Command to be send – rstallprof;
No response is returned for this command. Receipt of this command
initiates reset of profile parameters to default ones.
Deletion of all saved records.
Command to be send – deleterecords;
No response is returned for this command. Receipt of the command
deletes all the data packets from the device memory.
Set the value of the parameter by ID
Command to be send – setparam ####;
Parameter ID (####) consists of four digits and indicates the number of
the parameter. All configurable parameters are specified in the list of
device parameters (see
Appendix 1 and Appendix 2 ).
Example of response:
«Param ID #### New Val: #»
, where:
Param ID – ID of parameter to be set up;
New Val – assigned value of parameter.
Example of the command to set APN of the device (a parameter that
contains the APN device has ID 0242) –
setparam 0242 gps.utel.ua;