Water Tank
The Water Tank is the translucent tank at the end of
the Steam ‘n Clean.
1. Remove the Tank by unscrewing it from the
handle in a counter clockwise motion.
2. Remove the Water Fill Cap by unscrewing it from
the Water Tank in a counter clockwise motion.
3. Remove the Cap and the attached water tube
and siphon.
4. Fill Water Tank completely with cool tap water,
*
insert water tube/siphon, and replace Water Fill
Cap, turning in a clockwise motion until snug.
5. Reattach Water Tank by turning in a clockwise
motion until snug.
*NOTE: You may substitute distilled or demineralized water for tap
water. Doing so may reduce the need to change the Water Filter to
just once a year.
Do not add anything except cool water
or you will cause damage to the heating
element and void your warranty.
Water Filter
This filter removes minerals and other impurities
from tap water, preventing water deposits from
damaging your Steam ‘n Clean. It should be replaced
when the bright green grains turn dark blue in the
whole filter except the last strip.
4
How to use this guide
This User’s Guide has been designed to help you get
the utmost satisfaction from your Steam ‘n Clean
hand-held steam cleaner. You’ll find assembly
instructions for all cleaning tasks, safety precautions,
pre-cleaning tips, maintenance and troubleshooting
instructions. Please read this Guide thoroughly
before using your steam cleaner. Pay particular
attention to the parts diagram, assembly instructions,
and part names. Familiarize yourself with the tools
and how they’re used. Following the Guide will greatly
enhance your ability to get the best performance from
your Steam ‘n Clean for many years.
Your Steam ‘n Clean comes assembled and
ready to use. The drawing on page 3 and
part names may come in handy should you
need to order a part.
Power Cord
Unwrap Power Cord [with C.I.D. plug] completely
before operating unit.
Indicator Light
This will glow to indicate when tap water has been
converted to steam, and machine is ready to use.
Safety Lock
Slide forward to lock the Steam Switch OFF when the
Steam ‘n Clean is plugged in but not in immediate
use. When ready to use, slide back to activate the
Steam Switch.
Steam Switch
Push to release steam. To lock steam on, hold steam
switch down while sliding safety lock forward to
locking position.
Safety Valve
Your steam cleaner is equipped with a
safety valve
which will open if the steam nozzle is blocked. When
the safety valve opens, water will be released from the
small outlet hole at the bottom of the unit (below the
handle). If release continues, turn off your steam
cleaner, empty the Water Tank and call
BISSELL Consumer Services
1-800-237-7691
for repair/return instructions.
How to fill prior to sanitizing
