Bisonte BTA-12SDE, Руководство пользователя

Страница: 96 / 109

locks mutual locking cause the engine at the condition which may start. And now, the
operator can recoil –start the engine by hand according to the indication of instruction
manual.
②
If the engine is electric-starting model, carry out following two steps.(step2,3 are not
suitable for recoil start engine) connecting well the power supply and control switch as the
electric start hookup(or connect it beforehand). If the power tiller without power supply,
you should prepare a lead-acid battery accord with direct current 12V, 36AH.
③
Clockwise turn the starting-key to the start position after inspects unmistakably, and then
release the key after the engine started, it will return to the primary position automatically.
④
Adjust the throttling cock to the right position after the engine started.
⑤
Fasten upon the handle bar(Grasp the emergency stop handle and the handle bar with your
left hand), and buckle the trigger of emergency stop lock come out from the clutch handle
gently by your middle finger, the clutch handle restoration adown, then the clutch switch
on, and the machine start to work. You should grasp the emergency stop handle and
handle bar all the while in whole working course.
⑥
Meet emergency, release the emergency stop handle and handle bar, the engine will
flameout and the machine will stop working immediately.
7.
Stop the machine
①
Grasp the clutch handle, and make the clutch separated.
②
Pull the shift bar to the neutral position, loosen the clutch handle, switch the oil switch
clockwise to the minimum position, the machine will stop.
③
When stopping the diesel engine is needed, the stopping should be conducted according to
relative contents in the instruction manual. (Note: stopping the machine is generally
conducted on the flat ground)
Ⅵ
. Connection use of Auxiliary Devices & Tools
1. When cultivating is needed, knock down the wheels, fix the hexagonal union of the
cultivating device onto two ends of the hexagonal shaft of the running part, and axially fix
them with M8×55 bolt. Note: cultivating blades are divided into two groups, namely, the
left and the right. Fixing the blades should guarantee that when the machine is running,
the blade edge should work first. After fixing the blades, also fix the left and right
protection board for safety purpose. Depth of the cultivating can be realized by adjusting
height of the velocity adjustment screw and angles between the lever and the ground
( refer to table 4).
2. Cultivating for paddy field: when the submerged depth of human’s feet in the paddy field
is less than 25cm, bent blades for wet land can be directly used for the cultivating of
paddy field.
Deep Furrowing Resistance Stick
3. When ditching is needed, unlade the Deep Furrowing Resistance Stick, fix the ditcher,
adjust width & height of the ditcher, then ditching can be conducted. ( See Figure 3)
Width scope of ditching : 14cm-40cm
Depth scope of ditching: 11cm-25cm
4. Short distance transport
www.italiastar.ro
info@italiastar.ro
004/021.433.03.27
Italia Star Com Due S.R.L.
96