Bisonte BTA-12SDE, Руководство пользователя

Страница: 100 / 109

problems affect the normal use of the power tiller. To reduce chances of troubles, it is better to
do a strict and regular maintenance job which emphasizes precaution to keep a good
performance and extend its working life.
Ⅰ
. Breaking-in
1. Refer to the instruction manual for the breaking-in of the diesel engine
2. As for a new or overhauled power tiller, it should be working for 1 hour under no load or
5 hours under light load, then drain all the lubricant from the gear-box and crankcase of
the diesel engine, refill appropriate fix of clean diesel, and clean them at a slow speed for
3-5 minutes, then drain the diesel off. Refill engine oil into them according to 4/Clause
Three / Chapter
Ⅲ
to enter four hours breaking-in, then the machine can work.
Ⅱ
Maintenance and storage.
1. Keep all nuts, bolts and screw tight to ensure the equipment is in safe working condition.
2. Never store the equipment with diesel in the tank inside a building where fumes can reach
an open flame or spark.
3. Allow the engine to cool before storing in any enclosed place.
4. To reduce the fire hazard, keep the engine, muffler, battery compartment and diesel
storage area free of vegetative material and excessive grease.
5. Replace worn or damaged parts for safety.
6. If the fuel tank has to be drained, this shall be done outdoors
7.
After adjustment or maintenance, the safety protection guard must be attached to the
machine.
Ⅲ
Technical Service of Power Tiller
Clause One Maintenance by each work shift (conducted before and after each shift)
1. Listen and observe if there are any abnormalities of each part (such as abnormal sound,
overheating and bolt loosening)
2. Check if there is oil leakage in diesel engine, gear-box and Traveling box.
3. Check if the oil levels of the diesel engine and gear-box are between the two extremes of
the oil dipstick.
4. Timely clean the mud, weeds and smear on the machine and its parts.
5. Keep a good farming record.
Clause Two the first-rate service (every 150 working hours)
1. Do all the things listed for each work shift maintenance.
2. Clean the gear-box and Traveling box, and change the engine oil.
3. Check and adjust the clutch, shift system and reversing gear system.
Clause Three The second-rate maintenance (every 800 working hours)
1. Do all the things listed every 150 hours for service.
2. Check all the gears and bearing, replace with new ones if serious abrasion is found.
3. Other parts of the power tiller, like cultivating blade or connection bolts .if damaged,
replace with new ones.
Clause Four Technical overhaul (every 1500-2000 working hours)
1. Take the machine apart in the local special service center, clean and check the machine,
then replace or repair the seriously- attrited part.
2. Specialized service men are invited to check the friction piece and clutch.
Clause Five About the maintenance of the diesel engine, refer to the instruction manual
www.italiastar.ro
info@italiastar.ro
004/021.433.03.27
Italia Star Com Due S.R.L.
100