1
————— Instruction Manual —————
M
ODEL
SVB2000A
Recreational Sand Volleyball System
P A R T S L I S T
Item
Qty
Description
Item
Qty
Description
A
2
Poles
C
1
Volleyball Net
B
2
Slider Bars
See back page for optional volleyball court accessories.
♦
Inspect all contents prior to installation. Report any missing parts to dealer immediately.
♦
Read all instructions before proceeding.
1. Using the volleyball court layout, locate and dig two holes 8” in diameter by 17” deep 36 feet apart*.
Fill hole with wet premix concrete, insert
Poles
(A), making sure the
Slider Bars
(B) are square to and
facing each other. See Figure 1 and 2.
Date: 9/6/12 Rev: 9 B.A. N.J.C. File:\\server\publisher\instructions\svb2000.dwg , svb2000.pub Ref#: 960060
*** NOTICE ***
A minimum of 96” of pole must be left above
the playing surface.
Figure 1
2. After the concrete has cured loop the top rope
of
the
Volleyball Net
(C) around the top pulley
and into the rope cleat. Tie each
Volleyball Net
(C) tension string to its adjacent eyelet.
See Figure 3.
3. Once the
Volleyball Net
(C) is attached at both
ends you can adjust the tension by pulling
downward on the top rope in the rope cleats.
All height adjustments will require you to
loosen the top rope, loosen hand knobs, move
the
Slider Bars
(B) to the new position, then
tighten hand knobs and
Volleyball Net
(C).
Slider Bars
Playing Surface
8" Diameter
96"
17"
36'
Figure 2
