19
2. If the adjustable supports are correctly positioned, lift up the vehicle until its tires are slightly off the
floor. Slowly shake the vehicle with care to ensure that the supports are engaged and that the vehicle
is well-balanced.
3. After ensuring the restraint devices are engaged and that the vehicle is level front to rear and side to
side, push the control lever to lift the vehicle up to the desired height. During lift-up, listen for rattling
sounds made by the hydraulic drift prevention device.
4. Before starting work, ensure that the lowering stop hook is engaged.
9-4 During work
Keep the lowering stop hook “engaged” during work.
*Perform work with the lift raised up to a height at which
the lowering stop hook is activated.
Note that the lowering stop hook will not be activated
when the upper surfaces of the supports are
approximately 350 mm or less from the floor.
*DO NOT use the lift if the hydraulic pressure is released
from the cylinder after lowering the lift with the lowering
stop hook “engaged.”
*The chains will be elongated more or less under load.
If the vehicle is falling from the lift, move away quickly. DO NOT attempt to support the
vehicle.
DO NOT swing, shake, or push the raised vehicle.
*Keep anyone but the operator out from around the lift.
*DO NOT leave a vehicle on the lift for a long time.
*Before starting work, ensure that the lowering stop hook is “engaged.”
Warning
Caution
Danger
Warning
Caution
Hook control
lever
M post
“Engage”
“Disengage”
