Select suitable attachment depending on the lifting point of the vehicle.
1) Lifting Point is located within Upper Lift Top Plate range
Refer to 『 9-3-2 Put Attachment on Upper Lift Top Plate 』
2) Lifting Point is outside of Upper Lift Top Plate range
→ Use Swing Board
Refer to 『 9-3-3 How to use Swing Board Supporter 』
3) Lifting Point is located at Frame etc. of vehicle
→ Use Slide Arm
Refer to 『 9-3-4 How to use Slide Arm Supporter 』
If Lifting Point is located within Upper Lift Top Plate range, use and put
attachment on Upper Lift Top Plate.
・
DO NOT lift up any vehicle exceeding the lift capacity. Lift capacity of the Upper
Lift is 3,000 kgs.
・
Use only genuine attachment (Side Sill Block supporter) between Upper Lift Top
Plate and vehicle lifting point when lifting vehicle by Upper Lift.
・
When not in use, the lift must be lowered to the lowest position.
・
Make sure there is no oil or dirt on supporter when lifting vehicle by Upper Lift.
･
Stop lifting just before Side Sill Block would contact vehicle. Check if Side Sill Block
would fit to correct Lifting Point of the vehicle. If not, adjust the location
･
Check if Attachment is outside of Upper Lift Top Plate. If trying to lift up with
Attachment being outside of Upper Lift Top Plate, Attachment could come off and
vehicle could fall down.
