1. Weekly Clean Up
Clean up Wire Rope (Cable) every week with cloths soaked in oil, and remove dirt and sands etc.
2. Inspection and Replacing
Follow the below procedures for inspection.
① Within one year after installation, inspect the Wire Rope (Cable) every month.
After one year after installation, inspect the Wire rope (cable) every week.
② Visually inspect the wear, loose wires and breaking of wires.
③ Inspect and measure the OD of Wire Rope at few locations
by vernier caliper. Measure from 3 directions.
⇒
If average OD is less than Φ9.3mm, replace Wire Rope.
④ Replace Wire Rope if it lost its shape.
⑤ Replace Wire Rope if there is rust in Wire Rope.
⑥ Replace Wire Rope if Wire Rope is twisted and kinked.
⑦ Replace Wire Rope if Wire Rope was extended more than 10mm suddenly.
⑧ Replace Wire Rope if Wire Rope has breaking of wires.
Use lithium base grease.
-19 -
Double Pulley
Wire Rope End
Measure from 3 directions
・
In principle, replace the Wire Rope (cable) every 2 years.
・
Inspect the wear of Pulley and Pulley Shaft when inspecting Wire Rope (Cable), and replace if necessary.
Contact your lift supplier for replacing Wire Rope (Cable).
Lubricate Cable
after clean up
Grreasing
Greasing on Safety
Hook (4ea.)
Lubricate Oil (8ea.)
Lubricate Oil
Lubricate Chain
after clean up
Greasing
Greasing on Hook
Upper side(4ea.)
Lubricate Cable
after clean up
Lubricate Oil
on Safety Hook
Shaft(5ea.)
Greasing(5ea.)
Lubricate Oil
