BIS HSW, Руководство пользователя

Страница: 9 / 45

9
3. OPERATION
At startup the scale will be configured as last session.
3.1 Tare Balance
This indicator equips with auto tare, continuous tare (please refer to Fn.10 of internal setting) and
manual tare.
a) If auto tare function is enabled, the first weight being placed on platter will be automatically
tared.
b) If continuous tare function is enabled, each weight being placed on platter will be
automatically tared.
c) If manual tare is needed, place the load/container on the platter first and press TARE to tare
off the weight. After weight is tared, NET indicator will appear indicating the weight showing
on display is net weight.
To reset Tare Function proceed as follows:
a) To clear auto tare, remove the initial weight/load from the platter and NET indicator will turn
off. Press ZERO(↑) to return to zero weight status if →0← indicator does not appear.
b) To clear continuous tare, remove all loads from platter and NET indicator will switch off.
Press ZERO(↑) to return to zero weight status if →0← indicator does not appear.
c) To clear manual tare, remove everything from platter and press TARE, the NET indicator will
turn off. Press ZERO(↑) to return to zero weight status if →0← indicator does not appear.
3.2 Memory Function
How To Save A Weighing Result To Memory
a) Place a load on the scale and result will show on the display.
b) Wait the Stable signal appears then press M+/MC(←).
c) Weight result is now saved to memory and M+ indicator appears indicating memory contains
data.
d) Remove the load and scale will return to zero weight status.
e) Put on another weight and press M+/MC(←) to save the next weight.
How To Recall A Weighing Result From Memory
a) Press MR(↓) at anytime to recall the total result saved in memory, MR indicator appears
indicating the value shown on display is total result.
b) Result will remain on display for a short while before return to the previous screen.
How To Clear Weighing Result From Memory
Follow the below steps to clear saved data from memory after all transactions completed.
a) Press MR(↓) first to recall the total saved result from memory, the MR indicator will appear.
b) Press M+/MC(←) immediately to clear the memory and M+ indicator will turn off indicating