Instruction Manual
Truing Stand Calibration Gauge
20
20
10
10
0
Loosen the lead screws with a 4mm hex wrench, check that the uprights are movable.
Uprights
Reset the indication meter to 0.
20
20
10
10
0
Place the Calibration Gauge onto the uprights, ensure all sides are in contact and parallel.
Adjust the Uprights and Callipers simultaneously until the Calibration Gauge is centered.
Tighten up the lead screws.
Lead Screws
Caution :
Acts as a replicate of a perfectly dished wheel, used to realign the uprights
and calibrate the callipers of a truing stand.
To prevent deformation and loss of accuracy, external pressure and collision
should be avoided when storing the Calibration Gauge.
(BM17-WHTS-CAL-GAUGE)
