BIRD TENULINE 8320 Series, Руководство по эксплуатации

Страница: 24 / 35

8320 Series Tenuline® Attenuator
14
Repair Procedures
Repairs, beyond what is covered in this manual, may require return of the
equipment to Bird Technologies for service. See
"Customer Service" on page 20
.
Coolant Leakage Repair
If there are signs of coolant leakage around the clamping bands.

First attempt to tighten the bands.
If the leakage persists, it is likely that the O ‐ Ring seal is damaged or deteriorated
and should be replaced.

For Leakage at the Output End Cover, see
"Replace Coolant Tank Output
End Cover Seal" on page 14
.

For Leakage at the Input End Cover, See
"Replace Coolant Tank Input O ‐
ring Seal" on page 17
.
If leakage is significant, check the coolant level in the radiator tank. See
"Coolant
Level Inspection" on page 18
.
Replace RF Connector
The following procedure may be used to remove and replace Bird QC
connectors.
1.
Remove four 8 ‐ 32 round head machine screws from the corners of the
connector flange.
2. Pull the connector straight out.
3. Align the replacement connectors center contact pin with the socket and
seat QC connector.
4. Install four 8 ‐ 32 round head machine screws in the corners of the connector
flange to secure the QC connector in place.
Replace Coolant Tank Output End Cover Seal
The differences between models will be identified when a step applies to
specific model(s).