PRIOR TO INSTALLATION
Your complete Super BirdXPeller PRO kit includes a con-
trol unit, power adapter, battery cable with clips and four
speakers. Open the control unit by lifting the two latches
on the side of the enclosure.
Prior to operation, route the speakers and power cables
from their respective jacks on the control panel down
through the slotted rubber grommet in the lower part of
the enclosure, as shown in Figure 1.
IMPORTANT:
Be certain that the power
switch is in the OFF position and the vol-
ume control is set to the minimum (LOW)
volume level (counterclockwise) as shown
in Fig. 2 while plugging the speaker and
power cords into the control unit.
INSTALLATION
Important safety-related information:
a)
Do not install the device during rain or snow
conditions.
b)
Installation shall be made in such a way that a
power supply and the internal part of the control unit
never be subjected to water or snow.
c)
Note that a power supply powered from 230 VAC
is intended for indoor use only.
1) Use the mounting hardware (included) to mount the
control unit box to a wall, post or other vertical surface.
2) Plug the power adapter into an electrical outlet or attach
the battery clip assembly to a 12V battery. The other
end of the cable should already be plugged into the
power jack located below
POWER
on the front panel of
Digital Bird Repeller
play all of the speakers, but one at a time. (If the Random
Operation Switch is turned ON, then the speakers will
play one at a time in a random order. If the Random
Switch is OFF, they will play in a sequential order. To
operate the unit for
Speaker Operation
, set
Switch 6
in
Mode Settings
as follows:
Switch 6
Mode
OFF
One speaker at a time
ON
All speakers at one time
PROGRAMMING EXAMPLE
Recording Switches:
Results:
1, 3, 5 and 6 to “ON” position
Plays Sounds 1, 3, 5 & 6
Mode Switches:
1 = “OFF” position Time Off Interval is set to
2 = “ON” position
Medium, every 1 to 4 minutes
3 = “ON” position
Operates during daylight
4 = “OFF” position hours only
5 = “ON” position
Sounds in random, non-sequential order
6 = “ON” position
All speakers broadcast simultaneously
VOLUME CONTROL
The unit has a volume control dial on the front panel
of the unit. Turning the dial toward low will result in
reduced sound output and rotating the dial toward
high will result in an increase in sound output.
CAUTION:
Take care when turning the dial since the unit may be in
an inactive state when the dial is rotated. It could then reactivate at
a very high level of sound which could be painful to your ears.
POWER SWITCH
The power switch enables the unit to operate. Slide the
switch to the ON position to start the unit. If you turn the
unit OFF, be sure to leave it off for about 30 seconds
before turning it back on to allow the electronics to prop-
erly reset. To fully disconnect the unit, unplug the power
adapter from the electrical outlet or disconnect the battery
cable from the 12-volt battery.
TROUBLESHOOTING
300 North Elizabeth Street • Chicago, IL 60607
ph. (312) 226-2473 • fax (312) 226-2480
Toll Free US & Canada 800-662-5021
www.bird-x.com • [email protected]
EPA Est. No. 075130-OR-001
Fig. 2
SUPER BIRDXPELLER PRO #1 INSTRUCTIONS P/N #655-0056-00 (Rev. D)
Fig. 1
Slotted Rubber Grommet
This Super BirdXpeller PRO unit is warranted against
defects in material and workmanship for six months
from date of purchase (extended warranty available).
Bird-X will replace or repair, provided defect occurs
under normal use.
Returns accepted only with autho-
rization from our Chicago office.
Limited Warranty
PROBLEM
Unit is on,
but no sound is heard
Unit is on, but plays the
same bird over and over,
regardless of settings
Unit is not operating
properly in the
DAY or NIGHT mode
Unit does not function
properly when connected
to a 12 volt battery
• Check volume settings
• Check time of operation settings.
• Check that at least one bird is
selected to play.
• Double check Mode switch
settings
• Make sure photocell is not
obstructed.
• Make sure the photocell is not
affected by bright lights in either
the front or the back of the unit.
• Check battery condition
• Turn power switch on the unit to
the OFF position. Reconnect the
battery, wait 30 seconds, then
switch the unit back on
SOLUTION
• Reset the unit by turning it off for
30 seconds and then back on.
Product success takes time to build. Bird and pest habits may take
several days or weeks to break. Follow all suggestions for maximum
efficacy. "Instant" tests do not replicate natural conditions and give
no indication of the unit's success with the infestation.
Bird-X, Inc. has been recognized worldwide as the bird control x-perts
for 40 years. We have become experts through extensive experience
and research. As a result, we are happy to analyze problems and
make reommendations based on each customer’s specific situation
and needs. In addition, we provide the following recommendations
for greatest success, even before activating the repeller.
Remove inducements. Clean the area of all evidence of birds: nests,
fledglings, droppings, dead birds, and the residential scent. Because
birds and their droppings can carry many diseases, use extreme
caution when removing them. Do not breathe or come into direct
contact with them. If you have questions about how to do this safely,
consult an expert. (Adult birds are likely to return to their young in
order to protect them or to assist them in leaving the area.) Remove
food spillage, garbage, nesting material and other appealing items.
Survey the birds to determine flight and time patterns, entries and
exits, and nesting, feeding and roosting habits. This will suggest
the unit placement, speaker direction and time of operation you
should choose. Make educated guesses as to where the birds will
go when they are repelled from their current infestation, and consider
additional units to cover these alternative areas.
Maintain a clean and changing environment. Periodically clean the
area of nests and droppings, relocate or reposition the unit, vary the
output, or turn off the unit for a short time.
Install early, before “bird season” begins, as it is easier to keep the
birds away than to rout them out once they have established a living
pattern.
Use products synergistically. Two or more different kinds of devices
(this repeller plus a visual scare product and/or a roost inhibiting
device) will produce a synergistic effect -- i.e., in combination, the
products will yield much greater effectiveness than the one alone.
Contact us for information on “companion” products.
Prepare for Successful Bird Control
Successful Long-Term Behavior Modification
