RC
Duo 2
Turning on the remote
Communication with the sensor
2
3
Bidirectional remote control
Once the remote has been powered on,
G
will illuminate in red and begin to blink. To establish a connection with a particular sensor, aim
at the sensor and press
G
. The sensor’s address (1 - 7) will illuminate on the keypad. The sensor’s LED will briefly illuminate to confirm
communication. The RC Duo 2 is now ready to program the sensor. For help in selecting a particular sensor out of several, see section 4.3,
sensor scan mode.
The connection between the RC Duo 2 remote control and the sensor can only be established while the sensor is in
configuration mode
.
Configuration mode is activated when the sensor is switched on. For safety reasons, this mode is exited automatically 30 minutes after the
last setting has been made, and the connection between the remote control and the sensor is interrupted.
The connection can be
re-established
in one the following ways:
-
Pressing a button on the sensor
OR
-
Interrupting the electrical power supply to the sensor
OR
- Using the "access code" function on the remote control (only available on some sensor models)
Please refer to the sensor user manual for more information.
Quality
international
level
EN ISO
9001
Transmitter/receiver (infrared)
Status indicator LED
Safety curtain infrared spot detector
Numerical keys (1 to 9)
2” (5 cm) spacing for safety curtain infrared spot finder
Function keys (A to F)
Start button - power on (2 sec) & establish connection
Battery compartment
Battery compartment cover
Quick reference guides
(stored in slot on battery compartment cover)
General information
1
A
B
C
D
F
A
B
C
D
F
G
H
E
H
Page 1
I
J
E
G
I
J
B
Turns beeper function on/off (hold for 2 sec)
F
1
2
Scans for available addresses/sensors (hold for 2 sec)
On/Yes (only for certain parameters)
Off/No (only for certain parameters)
The RC Duo 2 must be powered on before it can communicate with the sensor.
POWER ON:
Press and hold
G
for 2 seconds
POWER OFF*
:
Press and hold
G
for 2 seconds
*The remote will automatically turn off after 2 minutes if no button is pressed.
Power ON:
Press
G
for
2 sec
Ensure remote is
powered on (section 2)
and sensor is in confi-
guration mode (section
3.1)
Once
G
blinks, press
G
again to establish
connection.
To address the desired
parameter
EXAMPLE: mounting
height - F4
Press
F
immediately
followed by
4
2
1
The sensor ack-
nowledges it’s current
set value by illumina-
ting it on the keypad.
EXAMPLE:
4
= 13-16 ft (4- 4.9 m),
factory default
The new setting is im-
mediately saved and
displayed on the key-
pad.
Programming of this
parameter is now
complete. Repeat for
other parameters.
Establishing connection with the sensor
3.1
Setting sensor parameters
3.2
Now press desired
new value.
EXAMPLE: 10-13 ft
(3.0-3.9 m) -3)
Press
3
The RC Duo 2 functions bidirectionally with the sensor. This means that changes to the settings on the sensor are immediately signalled back
by the sensor to the remote control.
EXAMPLE: the steps for setting the
Hercules sensor mounting height (parameter F4)
are shown below:
Parts of the remote
1.1
Shortcut buttons
1.2
2’’ (5 cm)
The sensor’s ad-
dress illuminates on
the keypad.
EXAMPLE: address
1
(factory default)
Note: If any keys are blinking, programming failed. In this case, repeat programming.
