1
1
5. Jumpers, Headers, Connectors & Slots:
(1) Floppy Disk Connector: FDD1
(1) Floppy Disk Connector: FDD1
(1) Floppy Disk Connector: FDD1
(1) Floppy Disk Connector: FDD1
(1) Floppy Disk Connector: FDD1
The motherboard provides a standard floppy disk connector that supports 360K, 720K, 1.2M, 1.44M
and 2.88M floppy disk types. This connector supports the provided floppy drive ribbon cables.
(2) Hard Disk Connectors: IDE1/ IDE2
(2) Hard Disk Connectors: IDE1/ IDE2
(2) Hard Disk Connectors: IDE1/ IDE2
(2) Hard Disk Connectors: IDE1/ IDE2
(2) Hard Disk Connectors: IDE1/ IDE2
The motherboard has a 32-bit Enhanced PCI IDE Controller that provides PIO Mode 0~4, Bus
Master, and Ultra DMA 33/ 66/ 100/ 133 functionality. It has two HDD connectors IDE1 (primary)
and IDE2 (secondary).
The IDE connectors can connect a master and a slave drive, so you can connect up to four hard disk
drives. The first hard drive should always be connected to IDE1.
(3) Peripheral Component Interconnect Slots: PCI
(3) Peripheral Component Interconnect Slots: PCI
(3) Peripheral Component Interconnect Slots: PCI
(3) Peripheral Component Interconnect Slots: PCI
(3) Peripheral Component Interconnect Slots: PCI
This motherboard is equipped with one standard PCI slots. PCI stands for Peripheral Component
Interconnect, and it is a bus standard for expansion cards. This PCI slot is designed as 32 bits.
(4) Accelerated Graphics Port Slot: AGP1
(4) Accelerated Graphics Port Slot: AGP1
(4) Accelerated Graphics Port Slot: AGP1
(4) Accelerated Graphics Port Slot: AGP1
(4) Accelerated Graphics Port Slot: AGP1
Your monitor will attach directly to that video card. This motherboard supports video cards for PCI slots,
but it is also equipped with an Accelerated Graphics Port (AGP). An AGP card will take advantage of
AGP technology to improve video efficiency and performance, especially with 3D graphics.
(5) Serial ATA Connector: JSATA1/ JSATA2
(5) Serial ATA Connector: JSATA1/ JSATA2
(5) Serial ATA Connector: JSATA1/ JSATA2
(5) Serial ATA Connector: JSATA1/ JSATA2
(5) Serial ATA Connector: JSATA1/ JSATA2
The motherboard has a PCI to SATA Controller with 2 channels SATA interface. It satisfies the SATA 1.0
spec and can transfer data with 1.5GHz speed.
Pin Assignment Pin Assignment
1 Ground 2 TX+
3 TX- 4 Ground
5 RX- 6 RX+
7 Ground
(6) Clear CMOS Jumper: JCMOS1
(6) Clear CMOS Jumper: JCMOS1
(6) Clear CMOS Jumper: JCMOS1
(6) Clear CMOS Jumper: JCMOS1
(6) Clear CMOS Jumper: JCMOS1
This jumper helps you to clear the Real Time Clock (RTC) Ram in CMOS. You can erase the CMOS RTC
Ram data to clear the CMOS memory of date, time, and system setup parameters.
JCMOS1
Assignment
Pin 1-2 Close
Normal Operation (default)
Pin 2-3 Close
Clear CMOS Data
18
