Quick Installation Guide
—
USB3.1 model
Introduction
This Quick Installation Guide(QIG) describes the packing content and
installation guide line for DVPro T10-USB3.1 model.
It also explains the function of each connector, and button.
It is served as a quick startup for basic
configuration, and the details
can be found on User Manual (downloadable from website)
Attention
BIOS AP and its resellers are not liable for any
data or information lost or possible software
error due to adoption of the product. We do not
take any responsibility of damage and/or system
malfunction due to our product / storage device
failure or for any of the problems caused as a
result It is recommended to always backup your
data.
World’s leading USB 3.1
RAID 6 Storage High
Capacity, Quiet and High Performance
10 x
3.5” SATA Drive Support
DVPro T10-U3
—
USB3.1 model
－
DVPro T10
– U3 model
DVPro T10-U3
Jul
. 201
7
Printing No: 0
2
Publisher BIOS AP Inc.
6F-6A., No. 5, Sec. 3, New Taipei Blvd., Xinzhuang Dist.,
New Taipei City 242, Taiwan
TEL: +886-2-8522-8393 FAX: +886-2-8522-8323
Email: [email protected] Website: www.biosap.com.tw
Change of Pre-configuration (Disk Size, RAID Mode, Number of Drives)
For any reason, if required, users can change pre-configured parameters including “disk size”,
“RAID mode”, and “number of drives”
Push and hold “Mode” and “Select” button at LCD panel, push power button once to turn on the
device. LCD panel should display “Array Parameter Setting” as below, and you can release both
buttons.
ARRAY PARAMETERS
SETTING
DISK Size
xxB
RAID MODE
RAID-6
Push Mode Button and you will see “Disk Size Setup”
Push “Select” button to choose disk size if wanted. Stop at the size of choice
Push Mode button to roll into RAID Mode setup if expected
Push “Select” button to choose RAID mode if wanted. Stop at
selected
RAID mode
RAID 6
or
RAID 5
or
RAID 0
or
RAID 10
Push Mode Button to choose number of drives (it shows as Drive Mode)
DRIVE MODE
10*
Push “Select” button to choose number of drives to be applied. Stop at number of drives needed
The last step is to save the change. Push both “Mode” and “Select” buttons at the same time once
to save the change. LCD should show “Power Down Please!”, if not push both buttons again. Power
down the device. Push and hold “Mode” button and power on the unit for new configuration to be
effective. After then, you need to format the new volume before using it.
